datasheets.com EBN.com EDN.com EETimes.com Embedded.com PlanetAnalog.com TechOnline.com  
Events
UBM Tech
UBM Tech

12 W Non-Isolated, Buck Topology, Power Factor Corrected, LED Driver Using LinkSwitch-PH

Authored on: Jun 1, 2010

Technical Paper / Reference Guide

0 0
More InfoLess Info
This document describes a non-isolated, high power-factor, TRIAC dimmable LED driver designed to drive 36 V at 0.33 A from an input voltage range of 90 to 265 VAC. The LED driver utilizes Power Integrations' LNK405EG device. LinkSwitch-PH was used to cost effectively design a single-stage, power factor corrected LED driver with primary-side constant current control. The LinkSwitch-PH controller was optimized for LED driver applications with minimal external components and control of the output current through the LED load without the use of an optocoupler. The non-isolated power factor corrected buck presented in this report shows how LinkSwitch-PH dramatically simplifies off-line, high-efficiency, power factor corrected LED driver design.
0 comments
write a comment

Please Login

You will be redirected to the login page

×

Please Login

You will be redirected to the login page

×

Please Login

You will be redirected to the login page