datasheets.com EBN.com EDN.com EETimes.com Embedded.com PlanetAnalog.com TechOnline.com  
Events
UBM Tech
UBM Tech

Design Tip: Simulating "Raw" Error Vector Magnitude (EVM) for a Quick Measure of a Circuit's EVM Performance

Authored on: May 25, 2009

Technical Paper

0 0
More InfoLess Info

You're designing a transmitter or receiver, or some part of one, maybe even the baseband chains. EVM (Error Vector Magnitude) or BER (Bit Error Ratio) may be the system specifications you must satisfy. This article has shown a quick method of obtaining relatively complex information about a design's performance. This speeds troubleshooting and enables quick feedback during the investigation phase of a design. It is also possible to simulate specification-compliant EVM (as well as many other specifications) when precise information is needed.

0 comments
write a comment

Please Login

You will be redirected to the login page

×

Please Login

You will be redirected to the login page

×

Please Login

You will be redirected to the login page